Water around a Midea dehumidifier usually points to a drainage issue: a bucket that is not seated correctly, a missing drain plug, or a hose that is loose, blocked, damaged, or routed incorrectly. First identify whether your unit is collecting water in its bucket, draining by gravity, or using a pump. Unplug the unit before handling its bucket or hoses, and use the manual for your exact model because connections and error codes vary.
Start with the leak and your drainage setup
Look for where water is appearing, then check how the unit is meant to drain. In bucket mode, water should collect in the bucket. With continuous gravity drainage, it should flow through a hose that descends from the unit to a drain. A pump-equipped model can push water through a hose, but that adds a pump filter and pump connection to check.
As an Amazon Associate I earn from qualifying purchases.
Find the model number on the silver nameplate at the back of the unit, then consult that model’s manual before buying a hose or following model-specific instructions. Midea’s FAQ explains where to find the model number and why drainage and error-code guidance depends on the model.
Free tools Windows power users keep installed
One-click scans. No signup required.
If you collect water in the bucket
- Unplug the dehumidifier. Remove the bucket and check for cracks, spills, or water on its exterior.
- Reinstall the bucket fully, following the manual. If it is misaligned, water may not be collected as intended; on some pump models, bucket fit is also part of pump troubleshooting.
- Check that the rear drain plug is installed. If the unit is supposed to collect water in the bucket, a removed plug can allow water to escape. Midea lists this as a cause of “Water on floor” in its EasyDry dehumidifier manual.
If you use continuous gravity drainage
- Unplug the unit before touching the hose or its connection.
- Check that the hose is attached to the correct drain outlet and seated securely. Look for a loose connection, damaged hose, or kink.
- Trace the hose to its destination. It must run downhill from the unit’s drain point; a section routed higher than the drain can prevent gravity drainage from working properly.
- Check that the hose end is open and directed into an appropriate drain or container. Confirm the exact fitting and connection procedure in your model’s manual.
Midea’s troubleshooting table lists a loose hose or hose connection as a cause of water on the floor. Its dehumidifier FAQ also says the hose route must not be higher than the unit’s drain point because drainage relies on gravity. If the hose is damaged, replace it only with one confirmed compatible with your model; a hose marketed for dehumidifiers is not automatically a fit.
#1 Best Overall
- 1,500 Sq.Ft. OF COVERAGE - Midea dehumidifier with drain hose is able to collect 20 pint (Similar to 30 PT-2012 DOE) of water a day and adjust humidity from 35% to 85%, perfect for use for basement, bathroom, bedroom, or crawlspace.
- SMALLER FORM, LARGER CAPACITY - Up to 3X larger water tank allows the Midea Cube dehumidifier to operate up to 3X longer than a conventional dehumidifier. You can enjoy more time without the hassle of emptying the water tank. Removable Bucket with 3.2 Gallons/12L bucket size.
- DEHUMIDIFIER WITH DRAIN HOSE allows CONTINUOUS DRAIN OPTION - Versatile, no-bucket option provides more flexibility to remove moisture. You can remove the water tank and place the unit above the sink using the included drain hose, or position it over a floor drain, near a window or door.
- SMART CONTROL -The Midea Cube dehumidifiers for home are Wi-Fi enabled and can be controlled from anywhere through the cloud using the SmartHome app on iOS or Android. You can also use voice commands throughout your house, office, or apartment using Alexa or Google Assistant.
- LIFT AND TWIST- World's first extendable dehumidifier for home offers unparalled flexibility - operate in extended or nested form. The nested design means you can easily find a place to store the unit when the space becomes dry, or extend it to its full capacity whenever you need it.
If your model uses a pump
Do not assume every Midea dehumidifier has a pump. If yours does, verify that the pump hose is connected to the correct port and fully seated, then check it for kinks, leaks, or blockage. Follow the manual’s pump procedure rather than applying instructions from another model.
For the models whose manuals specify these checks, clean the pump filter and inspect the hose and connections for debris or leaks. Midea’s EasyDry manual and Cube manual include pump-hose, filter, and bucket-fit checks in their troubleshooting guidance.
Rank #2
- 4,500 SQ. FT. DEHUMIDIFIER – Removes up to 50 pints of moisture per day with an adjustable humidity setting from 35% to 85%. Perfect for use in basement, bathroom, bedroom, office, kitchen, cellar, or crawlspace. Maintain a healthy 45%-55% humidity range
- ULTRA QUIET OPERATION – This model has quiet operation as 49 dBA（low mode). Enjoy sleep, a good book, or your favorite show without the disturbing noise of a traditional dehumidifier
- SMART CONTROL -This dehumidifier is Wi-Fi enabled and can be controlled from anywhere through the cloud using the SmartHome app on iOS or Android. You can also use voice commands throughout your house, office, or apartment using Alexa or Google Assistant
- SIMPLE DRAINAGE – Simply empty the water tank when it is full or connect a standard hose (not included) to the built-in socket for continuous draining. The dehumidifier automatically stops with a full water tank and restarts after the tank is emptied
- EASY TO USE – This unit was designed with a clean, sleek look to fit the style of any home, apartment, or office. With 360° rotatable wheels, digital control panel, and handles, easily move this dehumidifier to any room and use it with ease
If a pump hose is routed outdoors, observe the model-specific cold-weather warning. Midea’s Cube manual says not to operate that setup at or below 32°F (0°C): water may freeze in the hose, block it, and stop the unit. The MAD50PE1QWT-S guide also covers pump-hose connection and troubleshooting.
Quick wins for a faster PC:
Clear out junk files and repair common Windows errorsFree Scan →Fix the driver behind crashes, sound loss and screen glitchesFind Drivers →Quick Recap
Best Value
- 1,500 SQ. FT. DEHUMIDIFIER – Removes up to 22 pints of moisture per day with an adjustable humidity setting from 35% to 85%. Perfect for use in basement, bathroom, bedroom, office, kitchen, cellar, or crawlspace. Maintain a healthy 45%-55% humidity range.
- ULTRA QUIET OPERAION – This model has quiet operation as 47 dBA. Enjoy sleep, a good book, or your favorite show without the disturbing noise of a traditional dehumidifier.
- ENERGY STAR CERTIFIED- This unit is ENERGY STAR Certified and saves 31% energy when compared to traditional dehumidifiers.
- SMART CONTROL -This dehumidifier is Wi-Fi enabled and can be controlled from anywhere through the cloud using the SmartHome app on iOS or Android. You can also use voice commands throughout your house, office, or apartment using Alexa or Google Assistant.
- SIMPLE DRAINAGE – Simply empty the water tank when it is full or connect a standard hose (not included) to the built-in socket for continuous draining. The dehumidifier automatically stops with a full water tank and restarts after the tank is emptied.
Rank #4
- 4,500 Sq.Ft. OF COVERAGE - Midea dehumidifier with drain hose collects 50 pints of water a day and adjusts humidity from 35% to 85%. This unit is perfect for use in the basement, bathroom, bedroom, or crawlspace
- SMALLER FORM, LARGER CAPACITY - Up to 3X larger water tank allows the Midea Cube dehumidifier to operate up to 3X longer than a conventional dehumidifier. You can enjoy more time without the hassle of emptying the water tank. Removable Bucket with 4.2 Gallons/15.9L bucket size.
- DEHUMIDIFIER WITH DRAIN HOSE allows CONTINUOUS DRAIN OPTION - Versatile, no-bucket option provides more flexibility to remove moisture. You can remove the water tank and place the unit above the sink using the included drain hose, or position it over a floor drain, near a window or door.
- SMART CONTROL -The Midea Cube dehumidifiers for home are Wi-Fi enabled and can be controlled from anywhere through the cloud using the SmartHome app on iOS or Android. You can also use voice commands throughout your house, office, or apartment using Alexa or Google Assistant.
- LIFT AND TWIST- World's first extendable dehumidifier for home offers unparalled flexibility - operate in extended or nested form. The nested design means you can easily find a place to store the unit when the space becomes dry, or extend it to its full capacity whenever you need it.
Rank #3
- 3,500 Sq.Ft. OF COVERAGE - Midea dehumidifier with drain hose is able to collect 35 pint (Similar to 50 PT-2012 DOE) of water a day and adjust humidity from 35% to 85%, perfect for use in basement, bathroom, bedroom, or crawlspace.
- SMALLER FORM, LARGER CAPACITY - Up to 3X larger water tank allows the Midea Cube dehumidifier to operate up to 3X longer than a conventional dehumidifier. You can enjoy more time without the hassle of emptying the water tank. Removable Bucket with 4.2 Gallons/15.9L bucket size.
- DEHUMIDIFIER WITH DRAIN HOSE allows CONTINUOUS DRAIN OPTION - Versatile, no-bucket option provides more flexibility to remove moisture. You can remove the water tank and place the unit above the sink using the included drain hose, or position it over a floor drain, near a window or door.
- SMART CONTROL -The Midea Cube dehumidifiers for home are Wi-Fi enabled and can be controlled from anywhere through the cloud using the SmartHome app on iOS or Android. You can also use voice commands throughout your house, office, or apartment using Alexa or Google Assistant.
- LIFT AND TWIST- World's first extendable dehumidifier for home offers unparalled flexibility - operate in extended or nested form. The nested design means you can easily find a place to store the unit when the space becomes dry, or extend it to its full capacity whenever you need it.
What to do if water keeps appearing
- Recheck the drainage path that matches your setup: bucket seating and rear plug, gravity-hose fit and downward route, or pump-hose and filter checks where the manual specifies them.
- Look for a displayed error code and consult the troubleshooting section for your exact model. Codes are not universal: one Midea manual lists ES, AS, P2, EC, Eb, and E3, while Midea’s FAQ discusses particular codes and recommends customer service for certain persistent sensor or malfunction codes.
- If the leak continues after the external checks, or an error code persists, stop and contact Midea customer service or follow the model manual’s service guidance. Do not open the cabinet or attempt electrical or refrigerant-system repairs.
Product prices and availability are accurate as of the date/time indicated and are subject to change. Any price and availability information displayed on Amazon at the time of purchase will apply.
